I don’t know how many times I’ve been asked that question over the years, and my answer is pretty much the same: “It depends…” No, I’m not trying to be a dick, but it really does depend on what you’re after with your volume pedal.
The reason I’m bringing this up is because of a conversation I had yesterday with a friend and fellow guitarist. We were talking about amps and I mentioned how I set up my amp, with a particular emphasis on setting up my gain and volume on my amp. He asked me, “Why don’t you just put a volume pedal on your board?”
I told him I could do that, but I like to control my instrument volume from my guitar. He looked at me quizzically, and then it struck me that as a reggae player, he played almost entirely clean, so putting a volume pedal on his board would give him a volume bump. But then I shared with him that I couldn’t do that because of the way I set up my tube amps; that is, I set the volume to just at the edge of breakup on my amp so that when I turn up the volume on my guitar, I’ll go into overdrive, then clean up by turning the volume down. He was still a little puzzled at what I was talking about, so I gave him a crash course on tube amps (which I won’t go into here).
But that conversation sparked an idea to write about where to put a volume pedal in my signal chain and that then carried over into how it could be useful in various positions along my chain. So, given that, let me offer up some suggestions.
First, though, let’s go with the conventional wisdom of the general order of pedals on a board.
Distortion boxes (overdrive, fuzz, distortion) => Wah (I know, some people like them in front of dirt pedals) => Modulation pedals (Chorus, Flange, Vibe, etc) => Delay => Reverb.
I know, Delay and Reverb are modulation pedals, but it’s important to separate those out because they generally should be last in the chain. Also, I know that everyone has their preferred setup, but this is generally what you’ll find if you look it up.
So given that, where’s the best place to put a volume pedal?
- Put it in front of your distortion section to act like your guitar’s volume knob. This will push the front-end of your overdrive pedals and cause them to break up more (just like an amp).
- Put it at the back of your pedal board to provide an overall boost to your volume before the front-end of your amp. For tube amps, this could push your pre-amp tubes into overdrive. For solid-state or tube amps with tons of clean headroom, you’ll just get a volume boost.
- IF you have an effects loop, things can get interesting. 🙂 I actually run two pedal chains when I’m using my DV Mark Little 40. My dirt pedals go in front of my amp, while I place all my modulation pedals in the effects loop. If I were to use a volume pedal, it would be the very last pedal in my effects loop chain. The reason is that this would have a better effect on overall output volume, which is what I’m after, as it would act much like the master volume on my amp. This is also the place where I prefer to use a boost pedal as opposed to a volume pedal because all I’m after is a quick volume bump. And as long as I haven’t pushed my power tubes into saturation, I’ll get a few more dB of output volume which is great for playing solos. Note that this may even put my power tubes into saturation, and that’s not a bad thing.
Guitar Gear 